My First Car: Arrival of MOT test was make or brake time for Renault

PUBLISHED: 10:38 18 November 2016

Malcolm Ireson and his wife, Yvonne, had a Renault 8.3HP as their first car which needed some planning to stop.

Malcolm Ireson and his wife, Yvonne, had a Renault 8.3HP as their first car which needed some planning to stop.


Malcolm Ireson tells to fashioning a handbrake for his Renault 8.3HP to keep it on the road when the MOT test was introduced.

My first car was a 1939 8.3HP Renault – my mode of transport until then had been motorbikes.

The Renault had a four cylinder side-valve engine, three-speed gearbox, a six-volt battery, dynamo, coil, cut-out, ammeter etc and independent wishbone springing on front and one leaf spring on back.

The drum brakes were operated by cables attached to four lugs on a cross shaft under the car. When the foot pedal was pressed it turned the shaft and pulled on the brakes – usually. The handbrake was a pull type lever under the dash and, when turned, locked the foot pedal in the ‘on’ position. I hand painted the car and it looked good.

We drove to Kent in 1960 for our honeymoon in our little motor, remembering when applying the brakes to allow a big stopping distance! We had no heating, but a 28ft turning circle – it turned on a sixpence.

This before the Queen Elizabeth Bridge or the Dartford Tnnel and the Tilbury Ferry was the way over the Thames at that point – we just managed to get there to catch the last one that night.

When the MOT test came in, I think around 1962, my local garage man said the car wouldn’t pass the test becauss it had to have a separate handbrake system. I mumbled something to the effect that the car was built like that, but he insisted.

That weekend I welded a five-inch long piece of metal to the underside of the cross shaft and connected a bicycle brake cable to it and the handbrake lever.

I went back to the garage on Monday morning and persuaded the engineer to do test which, at that time, was done on the road. I drove with engineer sat in passenger seat with a ‘pendulum’ type measure between his feet. I applied the brakes when asked, first the foot brake and then the handbrake. The engineer, with no questions asked, was satisfied and produced the MOT certificate – obviously the hand lever was doing exactly the same as the foot pedal.

Those were the days.

Tell us about your first car and the adventures and scrapes you had – email your motoring memories with a picture of the car to or post it to Andy Russell, motoring editor, Prospect House, Rouen Road, Norwich, NR1 1RE.

If you value what this story gives you, please consider supporting the Norwich Evening News. Click the link in the orange box above for details.

Most Read

Most Read

Latest from the Norwich Evening News